Lisle LS40210 3/8" 28PC SOCKET HOLDER BLACK

These work really well for organizing, storing, and accessing sockets. The holder lays flat in the toolbox drawer, so you can use these in shallow drawers. I use drawer liners, and don't have any problems with picking up the entire holder (i.e. it doesn't get stuck to the drawer). I personally don't stick them to the side of the toolbox, as I don't want to risk any sockets falling out / getting bumped. The magnet is good for holding the sockets in place, but if you drop it, or bang it on something, then be prepared to chase a few. I haven't really had any problems with this though. There is room to mark or label the socket size (using permanent marker), which makes finding the socket you're looking for really painless -- and makes putting them away simple. If you have an apprentice/helper/gopher, this makes life easier for everyone. The deep-well side is deep enough to hold short extensions, or adapters and knuckles (or wobble). However, if you have a fully loaded Holder, picking it up solely by the handle tends to cause a crack over time -- not in the handle, but actually at the end of where the magnet is mounted, where the holder tends to flex. This isn't a dealbreaker, but is a design flaw to be aware of. I prefer the bright orange over the red, purely for contrast/readability of my labels. Regardless, I use these in every toolbox I own. Well worth it.

I would leave a five-star review because the quality of the material and the magnet are fantastic but the slot holes are kind of brand specific if you have heavy walled impact sockets they are not going to fit into these. My snap-on sockets fit in there but my Mac sockets will not. My Carlisle impact sockets fit perfectly but harbor freight brand or power built and Stanley are too thick to fit into these holders which I bought them to organize my miscellaneous sockets which did not work out so I ended up giving them to a co-worker

tray works good holds all the sockets but I find the magnet a little week. If your attaching it to a vertical surface it will slide down until it hits something that stops it. fortunately i store it in a tool box drawer

The only reason it got 4 stars was for the texture, it holds grease and makes it more difficult to wile clean. The one that this replaced was a smooth texture

If you plan on never taking this out of your tool box this for you. But if you plan on bringing it near your work space be careful not to get any chemicals on the plastic, it will melt.

Its nice but wont work for impact sockets