Ours broke and needed this asap...pool place by my was too expensive..this works perfect..kinda small..but it does the job

We have a tankless water heater with a condensate drain line vented to the outside of our house (required by local building code) through our garage wall. When it remains below freezing outside for more than a day the condensate drain line would freeze solid, blocking the drain line which then automatically shuts-off the tankless water heater when the condensate backs-up inside the unit. I had two choices to remedy this problem: 1.) Go outside in the sub-freezing weather on a twice daily basis and chip the ice out of the frozen drain line to allow it to drain, OR 2.) Install this 3-way diversion valve in-line in the condensate drain line inside our garage and simply drain the condensate in to a bucket in our always-above-freezing garage for the few very cold days every year when this is an issue. I chose option 2.) above and it works beautifully!! This is a true-to-size 1.5" PVC slip fitting valve. A 1.5" PVC pipe will fit perfectly inside the valve slip fittings. The valve is very high quality. Push the black handle to "unlock" and change the valve position, as it locks into place in each position.

I bought these for an off label use. Made a manifold to facilitate siphoning out carbon and softener resin out of tanks. I up sized the valve knowing any valve will NOT be full bore. (unlike everyone here who complained that it narrows down. Well Duh! First day doing plumbing?) If it leaks (but it doesn't/hasn't), not a big deal for me, its only in use for an hour or so. I'm happy, might be buying more to make for the other techs.

I like the simplicity of this tool. I need to be able to divert the outlet of my sump pump to any of two tubes. This product fits my purpose perfectly. The lever is a little hard to use, but works well and I don't need to use it frequently.

At first, I was concerned. The valves seemed stuck. Then I realized that you push down the handle to turn. That’s a nice feature. It felt a bit stiff at first, but was fine once I got the hang of it. It allows all 4 flow possibility (all directions, either flow option (left or right), or closed in all directions.

Great value... Great quality.... Value

I bought one of these in 2022 for my semi above ground pool. It leaked. I bought a second one thinking it was just a faulty piece. The second one leaks. Although it is a slow dripping leak, it leaks. Spend more money and get a better product. I could have probably paid less for one decent valve than I did for these two.

After the first valve failed at the seal, I foolishly ordered another one. The second one failed more dramatically, spraying my electrical panels with a steady stream of water.

We installed it ourselves. It is working very well so far!

The product is well priced. I used it for pool backwash diverter.

The handle is very short and DIFFICULT to rotate. Description is misleading. There are only 4 full open/full close detents... Full skimmer/full main, full skimmer/NO main, Full main/NO skimmer, Maintenance - main and skimmer both off (make sure your pump is OFF for this setting) None of the detents have markings, so you have to teach yourself the valve operation before you install it. To get percentages like 100 Skimmer, 50 Main, you have to eyeball it.. Because of the handle, I would probably choose Jandy/Pentair/Hayward! I will be extending the handle with PVC pipe for leverage. It is VERY difficult to rotate... which is why I replaced my original old valve in the first place!

Easy to install, small profile, and it was easy to use.

Perfect fit for 1-1/2 inch PVC. Bonded with PVC cement. Created a solid joint, easy to use, diverts water nicely

Not flimsy, works smoothly.

Easy install, rigid construction