Bought this little momentary switch to control a contact coil on my swimming pool. Once activated an flow switch keeps my pool pump running unless a water pipe burst and the water flow stops. In my mind I rather buy a little cheap switch of good quality then buy a pump that has burned up from lack of water. One last thing is the switch is somewhat water proof because of the rubber covering which seems to be functional, good quality, and reliable. Just a little piece of my at a low cost...

switches

Good

Work great, just what I needed!

Switches are nice they're easily to disassemble and reassemble they are independent sighted so you can run positive and negative through either side would recommend these switches to anybody long as you wouldn't using them in environments that could get wet because they are not waterproof in any way

Excelentes los productos no tengo quejas.

Worked just like I needed.

These do have plastic backs, not steel. The steel backed ones are more industrial, but you have to pay the price and work to find them. This one worked well for my application, and I can get rough on things. So far it is working well.

Installed into our 240 volt parts washer, and it working just fine.

Nice and quick delivery

They seem well made but the connectors are very small The screws for connecting will not hold a number 12 wire which is what you would use for it the 20 amps this switch is rated for.

Switches look to be great. Came with everything needed for installation. Only complaint is the small wire connection area.

Although these switches are rated for high voltage, I'm using them as speaker switches - They work great!

Good and durable switches for my offroad vehicle

I am using this DPDT switch as a mini Manual Transfer Switch for an RV rooftop A/C unit. I have two power sources GEN and Shore that I select from. This MTS will prevent power feedback when in a Generator Mode condition. The common output is a Furrion 15kHE rooftop A/C that draws a constant 14A on high fan speed (full bore). Nominally, 20A circuits would be either 10 or 12 wires. The Generator feed is 14 via a separate barrel selector switch. Since the draw is 14A then 14 wire is ok.Case in point, These screw type terminals are very small in size(maybe as small as size 4 screw). To connect anything larger than a 16-14 gauge wire requires a lug. Currently, I am using small yellow lugs that are mechanically crimped to the interface wires. I have taken and extra step isolating each contact with 3/8in silicon rubber tubing.I can safely state that the connections do get warm after running the A/C unit steady over time. I can also recommend some kind of lock washer or even better a star washer to keep these connections tight even after warming up and cooling down.Like I mentioned, these do work but may look into a Gardner Bender version that appears to have a larger contact surface area to support 12/2 and 14/2 electrical wirs. The TTHN 10 wire will still need lugs.The front end to this DPDT will have a Tyco W31-X2M1G-20 20 Amp Circuit Breaker Switch from the shore power feed circuit.

Nice switches smooth.

Standard size replacing my failed one on my 5th wheel camper landing gear system. Works great at handling the heavy current needed to operate the jacking motor.

Work good

These work as expected. No problems.

There are many similar brands of these simple toggle switches. These were a little heavier duty and more solid than the previous brand I tried. These look and feel like they will hold up well.