Made of great materials. Really nice wood.Not hard to assemble but it does take some force to get the hex screws in (use a screwdriver with a hex head and not the small tool provided).Regarding the SLIDING OUT DRAWER:After reading all the reviews of the drawer sliding out completely, I decided to add a stopper to it while assembling the valet.Here's my solution which I think is very simple, but feel free to improvise and use different methods:1) I cut a small piece of very hard cardboard (you can use wood) measuring about 3" long by about 0.5" W and 0.5" H. Basically a long rectangle about the size of your small finger. This will act as the drawer stopper.2) Remove the drawer.3) Measure where to place the stopper on the bottom side of the table, so it will stop the back board of the drawer before sliding out. This should be aligned about 0.25"-0.5" below the edge of the two wooden rails which hold the drawer in place.4) Use a very small screw (so not to breach the top of the table) and screw in the stopper onto the bottom of the table (you can also use carpenter's glue but I wanted to use a screw to make sure it will never fall out). Make sure the stopper is held securely in place.4) Now, you must remove ONE OF THE TWO RAILS in order to insert the drawer in place. Use a screwdriver to release the two screws which hold the chosen rail in place.5) After removing the rail, insert the drawer in place and see that the stopper functions properly.6) Now re-insert the rail which you previously removed and properly screw in the screws into their existing holes.7) Drawer does not slide out!Good luck.
Rating: [4 of 5 Stars!]