skip to footer block
Customer Reviews
Items 1 - 16 of 16 reviews
 1 
By Rob M
Date: May 01, 2018
Works. What else is there to say.
Rating: [5 of 5 Stars!]
By Dennis Dutton
Date: February 04, 2018
Boiler system is not getting water in for this to pump. So, can't say much about it.
Rating: [3 of 5 Stars!]
By Paul
Date: November 25, 2017
Perfect fit works great
Rating: [5 of 5 Stars!]
By Robert Leftwich
Date: October 30, 2017
Perfect replacement for the original.
Rating: [5 of 5 Stars!]
By Clif C.
Date: September 21, 2017
This cartridge works great! I would like to add an additional note that I have not seen anyone mention. It will make a rattling noise like there is a loose bearing rolling around in there. That's what I thought anyway. I called the tech support an they knew exactly what I was talking about. They said it's a anti-corrosion pill that will eventually dissolve. It would have been nice to have a little warning sticker, oh well. First world problems I guess.
Rating: [5 of 5 Stars!]
By Don
Date: August 27, 2017
just installed it works as expected
Rating: [5 of 5 Stars!]
By Code Cowboy
Date: June 07, 2017
Saved me a ton of money
Rating: [5 of 5 Stars!]
By Stan Fosaaen
Date: March 14, 2017
Shipped promptly and was as described.
Rating: [5 of 5 Stars!]
By Victoria
Date: February 14, 2017
It fits and works!!!!
Rating: [5 of 5 Stars!]
By Cody Ipsen
Date: February 12, 2017
I was told I couldn't get the part for five (5) weeks, but two days into my wait, I got a message that I would have it in 13 days AND I did. In the middle of a week of 40 below zero. Nice job, well done.
Rating: [5 of 5 Stars!]
By Anastasios G Karahalios
Date: January 25, 2017
Perfect
Rating: [5 of 5 Stars!]
By TH
Date: January 24, 2017
It is as described, works fine.
Rating: [5 of 5 Stars!]
By joe
Date: January 16, 2017
better than replacing the whole unit
Rating: [4 of 5 Stars!]
By Mark S Krueger
Date: January 01, 2017
It replaced my old one perfectly and had my heating system working again in 10 minutes
Rating: [5 of 5 Stars!]
By Buddha6
Date: July 13, 2016
A perfect and very easy replacement... less than ten minutes.
Rating: [5 of 5 Stars!]
By A Customer
Date: May 03, 2016
NOTE: Do NOT use any type of pry bar, etc. on the thin flange as it will deform and cause problems with sealing the pump after reassembly. I did a test fit of the cartridge and wanted to remove it for some reason so I made the mistake of gently prying against the flange and bent it just a little bit. The bolts are not meant for high-torque so don't think you can just 34;crank it down tight34; to get a better seal. I had to make a gasket from thin rubber gasket material to finally get a leak-free assembly.
Rating: [5 of 5 Stars!]
Items 1 - 16 of 16 reviews
 1