Alright I was researching these things for a while trying to find a good one, and there were many posts about these things not cutting straight or whatever.I got this and lo-and behold the paper wasn't being cut straight- BUT WAIT.All I did was change where I was cutting from, instead of hunched over a coffee table, I did it standing at a desk and things were cutting perfectly.It's just about angling and possibly pushing the paper too hard against the top leaving the paper to get angled a bit. It's user error, it's a straight blade that comes right down- not much to go wrong except if you are leading the bar and bending it a bit.The one issue I had was when moving it about, one of the rubber feet dropped off, another kinda got slid off, however that's from moving this thing around, which it wasn't meant to be doing.It cuts paper, not a boat load at a time but it does the job.
Rating: [4 of 5 Stars!]