Rugged Ridge 11509.14 Fortis Rear Tube Doors; 18-21 Jeep JL / 20-21 JT

Very solid. Heavy, not like the factory doors like some say though. I'd guess less than half the weight of one door. Finish was great. Install is a lot of back and forth. One doors latch stays locked open. Adjusting has nothing to do with it. Rugged ridge has the latch box set too low. It stays latched open off the jeep even if I try resetting the latch with a screwdriver. Soon as I loosen the latch box screws, it pops back into position. Pretty frustrating, but par for the course for most offroad companies. Edit: piece inside latch had a stamp mark on it preventing the latch from moving. Filed it down, works great. Leaving the number of stars because qc needs work.

very easy to install with all required hardware - very quick and easy to swap with stock doors - don't forget to order mirrors.sturdy latches that are easy to adjust

The doors are as advertised. Very easy to install and sturdy. Had a problem with one latch, and contacted the vendor who sold me these doors. They never picked up the phone and never called back despite multiple voicemails. HOWEVER, I located the manufacturer, who replaced the door immediately at no charge. So again: great product/manufacturer; lousy vendor with poor customer service.

The doors are as advertised. Very easy to install and sturdy. Had a problem with one latch, and contacted the vendor who sold me these doors. They never picked up the phone and never called back despite multiple voicemails. HOWEVER, I located the manufacturer, who replaced the door immediately at no charge. So again: great product/manufacturer; lousy vendor with poor customer service.

Rubber stopper at base of door prevents door from latching on my 2021 Gladiator. Restraining belt to keep door from opening too wide is too long and does not stop door from banging into side of my Gladiator when opened. I have tried contacting seller (Parts Hawk) but have been unable to get in touch

Was missing one but, but the company sent a replacement. Follow the instructions exactly for a clean install. Keep the bolts/screws lose until the very last step. Do not tighten any screws/bolts until the door is perfectly aligned, and then tighten at the very end together and will be perfectly aligned.