4.5 out of 5
Customer Reviews
Items 1 - 7 of 7 reviews
1
By
RS
Date: September 19, 2012
Folded too much when shipped.
Rating: 
[3 of 5 Stars!]
[3 of 5 Stars!]
By
FC
Date: February 11, 2011
I contacted Todd Emslie, an expert on receiving weak RF signals, and he claims that the degree to which these cables are bent by being bundled so tightly does not cause any significant problems. So, they should be suitable even to connect a UHF antenna to a preamp. Still, they do LOOK "kinky," and I don't understand why it's necessary to bundle them so tightly.
Rating: 
[4 of 5 Stars!]
[4 of 5 Stars!]
By
FC
Date: February 04, 2011
These cables, or at least the ones I got, were sent in a tight coil that is then flattened and tied with a twist tie, causing even tighter bends. Tight bends supposedly permanently change the cable's RF characteristics by distorting its cross-section where it is bent. I was going to use them for connecting TV antennas with weak output signals to a preamp, but decided not to use them because I can't afford to waste any signal. However, for larger signals and lower frequencies, they're probably fine, unless you mind their kinkiness.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
GA
Date: June 10, 2010
Does the job perfectly. Why pay more elsewhere?
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
FB
Date: May 27, 2010
Good stuff, can't beat the price.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
BR
Date: January 15, 2010
good
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
WH
Date: November 06, 2009
connector molding too large making it difficult to tighten nut.
Rating: [3 of 5 Stars!]
[3 of 5 Stars!]
Items 1 - 7 of 7 reviews
1