skip to footer block
Customer Reviews
Items 21 - 40 of 50 reviews
[Prev]   1  2  3  [Next] 
By randall
Date: June 06, 2024
really responsive, better than the one that came with it
Rating: [5 of 5 Stars!]
By Mark Kenneday
Date: May 17, 2024
I was able to find similar photo switches on the internet, but there were no instructions or wiring diagrams in the box. They worked fine but instructions would have been handy.
Rating: [4 of 5 Stars!]
By Paul Franke
Date: April 20, 2024
I looked very hard to find the original style and rating but couldn't. This photocell seemed to be used on lamps from all brands. The specs on it exceed the ones on the original photocell so I bought it and installed it, and it Is working well so we will see how long it lasts. Very easy job.
Rating: [5 of 5 Stars!]
By Sam McFall
Date: April 18, 2024
The shaft is smaller than it should be, also the wires are short to work with.
Rating: [3 of 5 Stars!]
By Toby Bishop
Date: April 08, 2024
I stripped the wires an extra 1/4” to get a better grip in the wire nuts.
Rating: [5 of 5 Stars!]
By Captain Bananas
Date: April 07, 2024
Easy repair for Altair outdoor lantern purchased from Costco. Bypassed original photocell and light came on, confirming that was the culprit. Simple to replace.
Rating: [5 of 5 Stars!]
By Ken
Date: March 11, 2024
works well
Rating: [5 of 5 Stars!]
By Jonathan Schubert
Date: February 26, 2024
Bought this to replace the dusk to dawn sensor in my car port light. Works as it should and was easy to install.
Rating: [5 of 5 Stars!]
By Cecilia Fontaine
Date: February 18, 2024
1stday installed on 2 old lights. So far so good. Now on to thousands of cycles before I replace again.
Rating: [5 of 5 Stars!]
By Richard K
Date: February 11, 2024
Easy to install and works as designed.
Rating: [5 of 5 Stars!]
By Honest John
Date: February 05, 2024
The dimensions stated are wrong! Shows as being 1.6 inches wide. NOT TRUE. Switch is 1.6 inches add the wire insulator and curve of wires the total is 1.95 inches. Careful if you have little room to install
Rating: [1 of 5 Stars!]
By John Garcia
Date: December 07, 2023
Received as advertised and as scheduled.
Rating: [5 of 5 Stars!]
By Paul M
Date: December 06, 2023
Fits perfectly into my Aluminum Lamp Post. The first one I bought worked fine but didn't fit properly. This one does. Not all photocells are alike. Be sure to measure your clearance (and thickness).
Rating: [5 of 5 Stars!]
By Jo
Date: November 28, 2023
They worked flawlessly for 12 years . Outside in the elements . Replaced them last week with the same model .
Rating: [5 of 5 Stars!]
By Thomas Cochrane
Date: November 13, 2023
Works great. Easy install. Lights doesn’t come on too early or too late. Just make sure sensor points away from the house for it to function correctly. You don’t want any reflective light from the light you are trying to control. Otherwise it will make the light continuously turn on and off.
Rating: [5 of 5 Stars!]
By Douglas M. Crockett
Date: November 06, 2023
This fit and worked perfectly as a replacement in our outdoor wall sconces. I don't know why the original dawn to dusk sensors like to fail, but it's nice to have an option that's much cheaper than the replacement part at Home Depot. Note that we use these with LED bulbs, so I can verify that the sensor works with at least some LEDs.
Rating: [5 of 5 Stars!]
By Tabitha
Date: September 14, 2023
Product was easy to install and works as it should.
Rating: [5 of 5 Stars!]
By janie godden
Date: September 04, 2023
Perfect size
Rating: [5 of 5 Stars!]
By Mary Kurtz
Date: August 12, 2023
This photocell fits in tighter spaces than the standard square ones available at the hardware store. Worked well for splicing into a light fixture instead of the post due to the curved edges. The rubber washers are thick and seal well.
Rating: [5 of 5 Stars!]
By Wm
Date: June 17, 2023
The photocell light sensor works very well. Easy to install.
Rating: [5 of 5 Stars!]
Items 21 - 40 of 50 reviews
[Prev]   1  2  3  [Next]