5 out of 5
Product Description
The best push-pull potentiometer ever made! These aren't your standard off the shelf CTS pots either. We had them custom made to our specification to have the smoothest taper possible and the tightest tolerance available.
-Custom taper for a smoother volume or tone control
-7% tolerance. Tightest tolerance available!
-Solid brass split shaft and bushing (3/8'' diameter x 3/8'' length)
Download the wiring diagram HERE
-Custom taper for a smoother volume or tone control
-7% tolerance. Tightest tolerance available!
-Solid brass split shaft and bushing (3/8'' diameter x 3/8'' length)
Download the wiring diagram HERE
Attention CA Residents: Prop 65 Warning
WARNING:
This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Return Policy
All MOJ- items are non-returnable.
Need more information?
Our staff are available to answer any questions you may have about this item
Our staff are available to answer any questions you may have about this item
Customer Reviews
By Michael
Date: August 09, 2023
Nice pot works well
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By Dominic N. Puleo
Date: December 17, 2022
If in doubt get some pot
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By mike
Date: October 23, 2022
A little bulky, so not great for tight spaces but good quality and very close to the specified resistance rating.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By Masterblaster
Date: July 07, 2022
I replaced a bourns 500k dpdt pot with this pot and I couldn't be happier, Bourns pot was way to noisy and super low torque, this pot seems to be better built than bourns and the noise level is significantly less, the only gripe I had was my schecter knob was very snug on this pot compared to bourns
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By Alex M
Date: September 19, 2021
I installed this as a tone knob an HSS strat build in order to get some single-coil bridge tones in addition to the standard humbucker. Unfortunately, the body for my Strat is a thin-bodied Squier, so I ended up having to do some routing in the control cavity to fit the height of this pot (though this will be the case with most all push/pull pots).Aside from that, the quality is great so far and it sounds wonderful. Would recommend.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By Thomas Cookson
Date: February 24, 2021
Prefect for modding my LP guitar
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
Items 1 - 6 of 6 reviews
1