CWD 150237 / HFPP 1 PR10 Pentek Big Blue Whole House 10 inch Filter Housing P7295095CWD-PENTEK-HFPP-PR10 https://cdnimages.opentip.com/full/CWD/CWD-PENTEK-HFPP-PR10.jpg 150237 / HFPP 1 PR10 Pentek Big Blue Whole House 10 inch Filter Housing This Pentek 150237 1” #10 Big Blue filter housing with pressure relief is suitable for high-flow and heavy sediment applications. The opaque blue sump is made of reinforced polypropylene for strength and resistance to chemicals, and the black cap is made of high-flow polypropylene (HFPP) for stiffness. The black cap has 1” female National Pipe Thread Taper (NPT) threaded input and output connections and a nitrile butadiene rubber (Buna-N) O-ring to ensure a watertight seal. A pressure relief button on the inlet side of the cap releases pressure in the housing for changing filter cartridges. The housing can be used with a 10” x 4-1/2” filter cartridge (sold separately). It has an initial pressure drop of 1 pound per square inch (psi) at a flow rate of 15 gallons per minute (gpm), a maximum operating pressure of 100 psi, and a maximum operating temperature of 100 degrees F (37.8 degrees C). This filter housing meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is for use in various high-flow applications, including residential drinking water filtration, food service, and irrigation, among others.SpecificationsFilter cartridge size (H x W) (sold separately) 10 x 4-1/2 inches (254 x 114 mm)Initial pressure drop at 15 gpm 1 psiMaximum temperature 100 degrees F (37.8 degrees C)Maximum pressure 100 psiMaximum dimensions (H x W) 13-1/8 x 7-1/4 inches (333 x 184 mm)Materials and structural integrity certification NSF/ANSI standard 42H is height, the vertical distance from lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.Water filters remove undesirable particles, chemicals, and microorganisms from water by means of a semipermeable barrier, adsorption, or biological processes. They are made of densely packed synthetic or natural fibers that trap suspended particles, materials that block microbes or adsorb unwanted chemicals, or substances that cause a chemical change, such as acid neutralization. For most residential, commercial, and industrial applications, water filters are manufactured in the form of replaceable cartridges that fit inside permanent housings. Filtration systems typically consist of a series of two or more types of filters, each designed to remove different contaminants. The performance of filters is measured by the minimum particle size that is blocked, the percentage of particles or microorganisms that are removed, the downstream concentration of unwanted chemicals, the maximum flow rate, and the amount of water that can be filtered before the filter must be replaced. Water filters are used in a wide range of applications, including drinking water purification, swimming pools, industrial processes, and irrigation, among others.Pentair manufactures industrial, commercial, and residential water filtration components and systems. The company, founded in 1966 and headquartered in Minneapolis, MN, meets International Organization for Standardization (ISO) standards 9001 and 14001 for quality assurance. 7295095 799932591297 5.95lbs 13.25 7.25 7.25
Pentek
32.2600 2022-12-02 86 In Stock
customer review - by , February 2, 2018
5/ 5stars
I have a water well. The water has small traces of sediment (sand) . I use 2 of these units in line before the water goes into my house. The first unit has a 75 to 25 ppm filter. The second unit down stream from the first unit has a 75 to 5 ppm filter. Collectively, I am very pleased with the water clarity. The "blue" outer housing is required when exposed to the sun. DO NOT USE A CLEAR outer housing.
customer review - by , January 1, 2018
5/ 5stars
great filter for the price. This filter will work great if you change the filter a needed.
customer review - by , January 1, 2018
5/ 5stars
Solid filter housing with reliable performance. Seals well. Be sure to purchase the wrench and mounting bracket for easy install.. ...
customer review - by , January 1, 2018
4/ 5stars
Product did not come with mounting bolts to attach to filter bracket. No instructions as to what to use. I'm at a stand still.
That's the only reason for a 4 star rating.
customer review - by , January 1, 2018
5/ 5stars
Small filter, big results. Use this with the refillable canister and DYI water conditioning for the whole house. My recommendation is to use some silicone grease to condition the o-ring inside every time you do a filter change/recharge. Has a pressure relieving button so it is easy to break the vacuum when changing out filters. Great product and will fit the 20" filter canister as well.
customer review - by , January 1, 2018
5/ 5stars
Arrived on t time and as described.
customer review - by , October 10, 2017
3/ 5stars
This is a good replacement filtration unit. If used in a new application - you would need to fabricate your own mounting plate.
customer review - by , October 10, 2017
3/ 5stars
This was a challenging canister to seal. The 1" connections required an insane amount of teflon tape to seal- even then I had to utilize food grade grease to keep from seeping. Main plastic canister also required grease to keep from dripping as well. I have a couple kenmore canisters that I have used that did not require all of this grease and tape to seal.

I can't say it is a terrible product because once it is sealed up it does its job just fine, just annoying to seal... definitely start the job with grease and plenty of teflon tape. I started with just tape and had to run out to a hardware store to find food grade grease (next to thread tape and pipe dope in most stores).
customer review - by , October 10, 2017
4/ 5stars
Update 10/12/2017:
I figured out what was wrong. There was a UPC barcode label stuck under the threads. My only issue with the unit is that the threaded in/out fittings aren't uniform. I was able to screw the fitting further into one side than the other.

Update 10/12/2017:
Something odd is going on. Doing some research, the filter for this housing should be 9 3/4" long. But my measuring tape is showing 10" long. How is this possible? This is probably why my housing is leaking! The filter I bought from Pentek is TOO LONG!

Small leaks around threaded in/out fittings. I'm working to fix the leaks. In order to stop major leaking from where the blue housing threads into the black top, I had to use a TON of silicone. Applying a 'small amount' on the o-ring' created a flood. I had to fill the trough where the o-ring sits with silicone and push the o-ring down into the bed of silicone. Im still trying to figure out if this is normal from other buyers.
I tried several different methods. 1) small amount of silicone, 2) hand tightened, 3) used wrench to tighten... all led to major leaks. The only way to stop it from leaking was to apply a TON of silicone.

I have no clue how other buyers were able to get a tight seal by only using 'small amounts' of silicone.

See attached image for the directional spray of water on the wall prior to using more silicone. Ill update this review if I can get all leaks to stop.
customer review - by , October 10, 2017
3/ 5stars
My experience is that you normally wrap teflon tape around threads 2-3 times to ensure a leak free connection in plumbing. I tried that with this filter and it leaked a lot at both of the pipe connections. I wound up putting over 10 wraps of teflon tape around the threads and now it only has a very slight leak on one side. The leak at the other side stopped. These plastic threads have some significant problem because I can't get a water tight seal at the pipe connection. I can't tighten it any more because the fittings are screwed all the way in to the filter. Maybe I'm supposed to use 20 wraps of teflon tape? Also, the holes at the top to mount it in the optional bracket are not threaded, so I had to thread those holes to accept the bolts that mount it to the optional bracket. Good thing I had a tap and die set. It does filter the water though, so I'll give it 3 stars. You just have to leave a bucket under it to catch the drips.
Share to:

150237 / HFPP-1-PR10 Pentek Big Blue Whole House 10 inch Filter Housing

Rating 5 | 73 reviews
Brand Pentek
See other products from CWD

Upc: 799932591297
SKU: CWD-PENTEK-HFPP-PR10
Price: $32.26
Quantity:
Shipping:
$15.32 To [ 20149 ] Estimated Delivery Date: Dec 8, 2021 to Dec 10, 2021
86 In Stock
Share & Earn 10% Cash Back Best Price in Bulk

You may also like

Optional related products

Product Description

This Pentek 150237 1” #10 Big Blue filter housing with pressure relief is suitable for high-flow and heavy sediment applications. The opaque blue sump is made of reinforced polypropylene for strength and resistance to chemicals, and the black cap is made of high-flow polypropylene (HFPP) for stiffness. The black cap has 1” female National Pipe Thread Taper (NPT) threaded input and output connections and a nitrile butadiene rubber (Buna-N) O-ring to ensure a watertight seal. A pressure relief button on the inlet side of the cap releases pressure in the housing for changing filter cartridges. The housing can be used with a 10” x 4-1/2” filter cartridge (sold separately). It has an initial pressure drop of 1 pound per square inch (psi) at a flow rate of 15 gallons per minute (gpm), a maximum operating pressure of 100 psi, and a maximum operating temperature of 100 degrees F (37.8 degrees C). This filter housing meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is for use in various high-flow applications, including residential drinking water filtration, food service, and irrigation, among others.
Specifications
Filter cartridge size (H x W) (sold separately) 10 x 4-1/2 inches (254 x 114 mm)
Initial pressure drop at 15 gpm 1 psi
Maximum temperature 100 degrees F (37.8 degrees C)
Maximum pressure 100 psi
Maximum dimensions (H x W) 13-1/8 x 7-1/4 inches (333 x 184 mm)
Materials and structural integrity certification NSF/ANSI standard 42
H is height, the vertical distance from lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.
Water filters remove undesirable particles, chemicals, and microorganisms from water by means of a semipermeable barrier, adsorption, or biological processes. They are made of densely packed synthetic or natural fibers that trap suspended particles, materials that block microbes or adsorb unwanted chemicals, or substances that cause a chemical change, such as acid neutralization. For most residential, commercial, and industrial applications, water filters are manufactured in the form of replaceable cartridges that fit inside permanent housings. Filtration systems typically consist of a series of two or more types of filters, each designed to remove different contaminants. The performance of filters is measured by the minimum particle size that is blocked, the percentage of particles or microorganisms that are removed, the downstream concentration of unwanted chemicals, the maximum flow rate, and the amount of water that can be filtered before the filter must be replaced. Water filters are used in a wide range of applications, including drinking water purification, swimming pools, industrial processes, and irrigation, among others.
Pentair manufactures industrial, commercial, and residential water filtration components and systems. The company, founded in 1966 and headquartered in Minneapolis, MN, meets International Organization for Standardization (ISO) standards 9001 and 14001 for quality assurance.

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Need more information?
Our staff are available to answer any questions you may have about this item


Look Similar Items By Category


Customer Reviews
By Raymond Reed
Date Added: Sunday 04 February, 2018
I have a water well. The water has small traces of sediment (sand) . I use 2 of these units in line before the water goes into my house. The first unit has a 75 to 25 ppm filter. The second unit down stream from the first unit has a 75 to 5 ppm filter. Collectively, I am very pleased with the water clarity. The "blue" outer housing is required when exposed to the sun. DO NOT USE A CLEAR outer housing.
Rating: [5 of 5 Stars!]
By Butch
Date Added: Monday 29 January, 2018
great filter for the price. This filter will work great if you change the filter a needed.
Rating: [5 of 5 Stars!]
By Jodisan
Date Added: Tuesday 16 January, 2018
Solid filter housing with reliable performance. Seals well. Be sure to purchase the wrench and mounting bracket for easy install.. ...
Rating: [5 of 5 Stars!]
By George Riedmuller
Date Added: Thursday 11 January, 2018
Product did not come with mounting bolts to attach to filter bracket. No instructions as to what to use. I'm at a stand still.<br />That's the only reason for a 4 star rating.
Rating: [4 of 5 Stars!]
By J. G. Smerda
Date Added: Thursday 11 January, 2018
Small filter, big results. Use this with the refillable canister and DYI water conditioning for the whole house. My recommendation is to use some silicone grease to condition the o-ring inside every time you do a filter change/recharge. Has a pressure relieving button so it is easy to break the vacuum when changing out filters. Great product and will fit the 20&#34; filter canister as well.
Rating: [5 of 5 Stars!]
By Robert L. Roy
Date Added: Tuesday 02 January, 2018
Arrived on t time and as described.
Rating: [5 of 5 Stars!]
Items 1 - 6 of 73 reviews
 1  2  3  4  5 ...  [Next] 

Your Recent History