Free Shipping Promotion: Buy more items from the same series, product code beginning with PEX-, and you can get free shipping for an order of over $150.00 consisting of only PEX- series products. NOTE: Items with a product code not beginning with PEX- in the order will still be charged a shipping fee.
Manufacturer Part Number: 245-873
Overview: The Xdirect is a high quality interface that lets you connect instrument, line, or speaker level signals to a mixer or other balanced input.
Compact, rugged aluminum case
Audiophile-grade low-noise active electronics
Product Details: ART Xdirect Professional Active DI Box
The Xdirect™ is a high quality interface that lets you connect instrument, line, or speaker level signals to a mixer or other balanced input. The high impedance single-ended 1/4" and XLR inputs are buffered and converted, by very low noise active electronics, into an isolated balanced low impedance signal source. The Xdirect has an extremely flat and wide frequency response and can handle high signal levels while still maintaining an isolated balanced low impedance output. This gives the Xdirect a very clean and neutral sound with a wide variety of signal sources and over long signal runs in high noise environments.
The Input Attenuator switches allow for a wide range of signal levels and the Input Link jack allows for tapping off of your signal chain. The Ground Lift switch lets you totally separate the input and output signal grounds, when appropriate, to isolate two systems, thereby reducing hum and ground-loop noise.
What further sets the Xdirect apart from other "Active DI" boxes are its extended features and versatility. ART has added a switchable low pass filter that cuts out all very high frequency interference. This Bessel filter on the input is placed out of the audio range and is primarily intended to reduce radio frequency interference before it gets into the main system. The filter is also very effective in reducing any digital computer noise artifacts when using the Xdirect as an interface between a computer based audio workstation and your monitors.
A Phase Invert switch, while not normally included with your run of the mill D.I. box, has been added to allow you to switch signal polarity right at the source. This feature is especially handy when you are combining a direct tap with a microphone feed in the mix.
The Xdirect's active circuitry is powered by an internal 9 volt battery, when external power is not available. In this mode it draws 3.5 milliamps which should give you more than 250 hours of operation off of a new battery. If phantom power is available, then the Xdirect will automatically draw its power from the external source. The Battery on/off switch lights dim when the unit is running off of the battery, lights brightly when it is running off of phantom power, and is off when the unit is inactive.
The compact black anodized all aluminum case and its flexible power design allow the Xdirect to provide years of trouble free service in Live Sound, Permanent/Fixed Install, D.J., and virtually any PA application. Its full feature set, rugged construction, and high-end specifications make the Xdirect the obvious choice whenever you have to interface high impedance sources with a low noise balanced system.
Specifications: • Frequency response: 10 Hz to 100 kHz • Maximum output level: +6 dBu (battery powered) +14 dBu (phantom powered) • Maximum input level: +4/+24/+44 dBu • Dynamic range: Greater than 100 dB typical • Input connections: 1/4" TRS and XLR female unbalanced, 470 k ohm • Output connection: XLR male balanced, 600 ohm • THD: Less than 0.05% typical • Filter type/response: Switchable, low pass, -3 dB @ 30 kHz • Input attenuation: Switchable, (0 dB, -20 dB, -40 dB) • Output phase: Switchable, normal/invert • Ground lift: Switchable, fully isolates inputs from chassis and output • Power requirements: 9 V @ 3.5ma (internal battery) or 18 VDC to 48 VDC @ 9.5ma (phantom power) • Dimensions: 1.75" x 4.2" x 3.5" • Weight: 0.75 lb.
Active / Passive: Active
Rack Mountable: No
ART Xdirect Professional Active DI Box
Part Number: 245-873
Product Category: Direct Boxes
Unit of Measure: EA
Weight: 1 lbs.
NOTE: International/PO BOX deliveries are not available.
This product does not ship to the APO address and the following state(s): HI, AK, PR.
6,000 + (and growing) factories in our existing network are eager to make it for you.
When it comes to selling in stock products, we are no difference from many other Internet retailers, but we take pride in going extra miles to do something special for you: Have some products custom made for you.
We cannot do everything, but we usually can accommodate a certain changes in product options such as color, size, material, or minor design twist. We primarily work with vendors or factories, not individual artist or craftsman. For custom made products, we usually only cater to bulk size order that meets the minimum quantity requirement of a single factory run. Don't be shy. Ask. What we can accomplish may surprise you!