I would have given this probably 3.5 stars. but there isn't a half star.When I received these, I thought maybe they were partially assembled, NOT.I comes in a box that is roughly 6' L x 3' W x 6" H.Everything is in pieces except for the burner which i believe they want you to disassemble later. (yes disassemble)The product is packed up ok. Lots of boxes, bags, foam etc, although one of my (kits) were a little jumbled up but ok.So not getting into all of the assembly details, there were a couple of things to look out for, not necessarily look out for but be aware of. First and probably the most important, all edges of the stainless steel is very sharp. Nothing is de-burred. It is all stamped and thus can cut flesh!Second, most of the metal is covered with a protective film that is somewhat hard to remove, at least time consuming and annoying!I hope you're not in a hurry cause this thing will take several hours to build.Also watch the orientation of the bottom base and mid burner section, as there is a front to both.I found the included stubby screwdriver not to fit the screw head, so I ground the tip a little, which helped a lot.Some of the screw holes did not line up on one unit, so I had to file out the holes and also some threads did not fit correctly, lucky I had a M5 tap and chased several threads.Did I mention that all of the edges were sharp?Some screws are very hard to get too, and this is why I think they want you to disassemble the burner, but I just put the frame together first before putting in the 3 main supports, lower, mid (burner) and top.Once you put together one, the next goes a lot faster, assuming you are going to do more than one.I didn't cut any knuckles or palms on the second one, and figured out some shortcuts too.It seems that they (China) forgot to put some clips for the bottle strap inside, although there is a rubber ring on the bottom plate that doesn't seem to have a purpose except to guard the sharp edges on the hole and that the strap is suppose to go through the hole, but there is no rubber on the other hole where the strap comes back up through?I put some edge protectors on it. You can use a small rubber hose that is split.Now everything is screwed together and bottle installed. Poof, it works.BTW, i wiped all of the finger prints off, as they will leave marks in time with the heat.Also something I noticed after installing the roller wheels. The bolts are tooooo long. The ends hit the hard rubber wheels and they will not roll, so I just used several washers under the head to space it away.Now I get to put it through the heat test this weekend for a funeral! We'll see how it holds up.
Rating: [4 of 5 Stars!]