Wilson Cellular Smart Technology 60dB In-Building Wireless 800MHz Cellular Bi-Directional Amplifier

Cellular Amp, BDA for providing wireless in-building coverage. Replaces 801104. (Cell Phone Amplifier/Repeater)

Detailed Description
Wilson Cellular's new series of Smart Technology In-Building Cell Phone Amplifiers offer exceptional performance without causing harmful interference to the cell site.

Wilson Cellular Amplifiers extend cellular services in poor coverage areas by amplifying both transmit and receive signals. The amplifiers reduce problems with signal fades and dropped calls while improving voice quality, service range and access. These multi-mode amplifiers are designed to offer a cost-effective solution for use in buildings. Wilson Cellular amplifiers are network compatible and enhance the cellular phone user's satisfaction without comprising the operation of the cellular system.

This Amplifier-Repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously.

The signal from the cellular tower is received by the outside antenna and then amplifier and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna and then amplified/repeated through the outside antenna to the cellular tower.

Features:

Greater than 60dB computer controlled adjustable AGC dynamic range
Automatic Gain Adjusting in the event of oscillation and/or overload
2dB Gain Steps (30 - 60dB)
Automatic shutdown on overload
Uplink squelch (optional)
TIA/EIA-98-E 3.5.1 Receiver Sensitivity better than -110 dBm
CDMA/rho > 0.912
Wireless operation - no physical connection to cellular phone
Maximum 3 Watts Output Power
High Power Output Allows More Users on the System
Increases signal strength in buildings for AMPS frequencies
824-894MHz
Analog/Digital (CDMA, TDMA, GSM)
1900MHz band is unaffected/unamplified
Allows multiple phones to be used simultaneously
Increases your cellular phone's range
Provides 9 times the coverage area of the 50dB Amplifier
When designing your system, please be sure to allow for 70' of separation between the interior and exterior antennas (20' which must be vertical).

Requires:

Outside antenna (recommend Yagi)
Inside antenna (recommend Ceiling Mount Dome Antenna)
Ultra Low Loss Cable

Compatibility:

Compatible with all 800MHz Cellular providers (CDMA, TDMA, GSM, Analog). For example, most Verizon, AT&T TDMA, Alltel, US Cellular and many more
Not compatible with 1900MHz PCS (AT&T GSM, Sprint PCS, T-Mobile, Qwest)
Not compatible with iDEN (Nextel, Southern LINC, Mike)

Specifications

Part Number 801106
Frequency 824-849MHz Uplink
869-894MHz Downlink
Gain (up/down) 60dB / 60dB Max
Linear Output Power +30dBm
Max Output Power 3 Watts
Max RF (up/down) +30dBm / +30dBm
Noise Figure (typical) 3dB Nominal
Flatness (up/down) +/- 2.5dB
Isolation > 90dB
Power Requirements 120VAC, 225mA Max
Connectors N/Female, 50 Ohms
Dimensions 4.5 * 3.5 * 1.25 (inch)
Weight 1.5 lbs