Product Description
Cellular Amp/BDA for providing wireless in-building coverage. Replaces 804003. (Cell Phone Amplifier/Repeater)
Detailed Description
Wilson Cellular's new series of Smart Technology In-Building Cell Phone Amplifiers offer exceptional performance without causing harmful interference to the cell site.
Wilson Cellular Amplifiers extend cellular services in poor coverage areas by amplifying both transmit and receive signals. The amplifiers reduce problems with signal fades and dropped calls while improving voice quality, service range and access. These multi-mode amplifiers are designed to offer a cost-effective solution for use in buildings. Wilson Cellular amplifiers are network compatible and enhance the cellular phone user's satisfaction without comprising the operation of the cellular system.
This Amplifier-Repeater greatly improves signal strength inside a building when using your cellular phone. It does this without a physical connection to your phone, allowing you to walk freely during a call. It even allows multiple phones to be used simultaneously.
The signal from the cellular tower is received by the outside antenna and then amplifier and repeated to your phone through the inside antenna. When the phone transmits it is received by the inside antenna and then amplified/repeated through the outside antenna to the cellular tower.
Greater than 50dB computer controlled adjustable AGC dynamic range
Automatic Gain Adjusting in the event of oscillation and/or overload
2dB Gain Steps (20 - 50dB)
Automatic shutdown on overload
Uplink squelch (optional)
TIA/EIA-98-E 3.5.1 Receiver Sensitivity better than -110 dBm
Wireless operation - no physical connection to cellular phone
Maximum 3 Watts Output Power
High Power Output Allows More Users on the System
Increases signal strength in buildings for iDEN (Nextel, Southern LINC, Mike) frequencies (806-866MHz)
Allows multiple phones to be used simultaneously
Increases your cellular phone's range
Low cost solution for uncompromised performance
Overload Protection on Uplink and Downlink
Receive/Transmit Overload Indicator Lights
Low Isolation Indicator
Also works for direct connect communication
When designing your system, please be sure to allow for 45' of separation between the interior and exterior antennas (20' which must be vertical).
Requires:
Outside antenna (recommend Yagi)
Inside antenna (recommend Ceiling Mount Dome Antenna)
Ultra Low Loss Cable
Compatibility:
Compatible with iDEN Carriers (Nextel, Southern LINC, Mike). Compatible with iDEN Cellular calls and Direct Connect.
Not compatible with 800MHz Cellular (Verizon, AT&T, etc) or 1900MHz PCS (AT&T GSM, Sprint PCS, T-Mobile, Qwest)
Nextel Rebanding note: Due to interference between the Nextel 800MHz band and the Public Safety 800MHz band, Nextel will be moving their service to the 900MHz band. What this means is that at some point your 800MHz repeater will need to be replaced with a 900MHz repeater.
Specifications
Part Number 804005
Frequency 806-821MHz Uplink
851-866MHz Downlink
Gain (up/down) 50dB / 50dB
Linear Output Power +30dBm
Max Output Power 3 Watts
Max RF (up/down) +30dBm / +30dBm
Noise Figure (down) 3dB Nominal
Flatness (up/down) +/- 2.5dB
Isolation > 90dB
Power Consumption 120VAC, 225mA Max
Connectors N Female, 50 Ohms
Dimensions 4.5 * 3.5 * 1.25 (inch)
Weight 1.5 lbs
|
Overstock Clearance
